✔ Adding non-numeric entries in the Block Property ID field
Completed by Irit W.
- Assigned to
-
Martin L.
- Notes
-
Hi
Using UN/0110/06 as an example. I'd like to make this section fall under one ID tag: Annex (pages 7 to 22 of the PDF). These pages will not be needed for Analysis, but I think it's best to give them an "Annex" ID tag just in case.
1) I am not able to enter "Annex" into the ID field.
2) Can I give the same ID to an entire section, even if I add the sections as several boxes through the converter tool?
The current logic "hard-codes" the ID prefix based on the selected Block Type. But we could add a way to override this if needed.
In terms of using the same ID in several blocks, it is possible and it will not cause any error per se, but it's probably not best practice to do so.
What would the purpose of "Annex" ID be? Who would use it? Would it be referred to from other areas of the document?
Thanks,
-Martin
I pushed a new version out to address this issue. Can you test it out and report back?
2 changes were made:
Thanks,
-Martin
Irit